—  Two colours, one clear message  green for closed and clear to pass, red for moving or alarm, readable from the far end of the aisle.

—  IP67 with full white resin potting  the strip is sealed inside the profile, so condensation and internal fogging cannot form in cold rooms or humid plants.

—  Silver aluminium body  extruded profile acts as heat sink and keeps the bar straight on long spans, with a sealed end cap around the cable exit.

—  9.6W per metre at 24V  a 900mm bar draws about 8.6W, light enough to run from the door controller supply without extra wiring.

—  60cm, 90cm, 120cm or custom to 2m  standard sizes cover most frames, with bespoke lengths and custom cable runs for wider openings.

—  Clip or tape mounting  stainless steel snap clips grip the rear of the profile, or 3M VHB tape where the frame cannot be drilled.

—  CE, RoHS and five year warranty  compliant for EU industrial projects, with five years of cover on every unit.

This is a status signal, not a work light. Mounted on the door frame at eye level, the bar gives anyone approaching the opening a single, unambiguous answer: green light means the door is shut and access is clear, red light means the door is in motion or the alarm is active and entry must wait. For forklift traffic and cold store staff moving between temperature zones, that one glance replaces a shout, a horn or a look over the shoulder.

The 5050 strip is set inside a heavy duty U shape aluminium channel and sealed with solid white resin, which stops condensation and internal fogging and holds IP67 against washdown, frost and humid plant air. The aluminium body carries the heat away and keeps the bar flat along its length, and the moulded end cap seals the cable exit. Power draw is 9.6W per metre at 24V, so a 900mm bar runs at about 8.6W and can share the supply already on the door controller.

Standard lengths are 60cm, 90cm and 120cm, with bespoke lengths from 30cm to 200cm for wider frames and special equipment. Fixing is a stainless steel snap clip that grips the rear of the profile, or 3M VHB tape where drilling is not allowed; in both cases the luminous face stays fully exposed. Cover options in white glue, clear glue or opal PC let the same profile suit different brightness and service needs, and cable length and waterproof connectors are made to order. Units are CE and RoHS compliant and carry a five year warranty.