—  UGR below 19  the diffuser and optical layout keep glare out of the work plane, so screens and desks stay readable under load.

—  120 lm/W at 230V  high efficacy from a built-in isolated driver means fewer fixtures and lower connected load for the same illuminance.

—  Driver inside the profile  230V AC mains straight into the fixture, no separate driver box in the ceiling and no low voltage cabling.

—  50 x 70mm AL6063-T5 body  extruded aluminium acts as the heat sink and holds the line straight over long continuous runs.

—  Three colour temperatures  3000K, 4000K and 6000K share one profile, so an office scheme can move from warm circulation areas to neutral work zones.

—  600mm 20W and 1200mm 40W  standard lengths suit most layouts, with custom lengths to close out a run to the wall.

—  Specification grade compliance  CE, RoHS, WEEE and LM-80 tested, Class I for indoor use, with a five year warranty behind every unit.

The ALP5070 is a specification grade linear fixture rather than a decorative strip. A 120 degree opal diffuser spreads the LEDs into a soft, even plane of light, and the optical design keeps UGR below 19, so people sitting under it read screens and documents without the reflected glare that plain batten fixtures produce. Colour rendering above Ra80 keeps materials and skin tones natural, which is why the same fixture works over workstations, meeting tables, reception counters and merchandise.

Everything sits inside the 50 x 70mm extruded AL6063-T5 profile: the 230V isolated constant current driver runs at 600mA and is built in, so there is no separate driver box to mount in the ceiling void and no low voltage cable to pull. The extrusion acts as its own heat sink, and the internal channel has room for the driver and wiring, which keeps the external face clean along the whole length. End caps are fitted at the factory, so the fixture arrives as a finished unit.

Standard lengths are 600mm at 20W and 1200mm at 40W, with custom lengths available for continuous runs and project layouts. Each fixture is supplied with surface mounting clips; a 1.5m steel wire pendant kit and connectors for linking runs are ordered separately, so specify the suspension when the job calls for hanging installation. Laser engraved logo and branded cartons are available for OEM orders. Units are CE, RoHS and WEEE compliant, LM-80 tested and covered by a five year warranty.